Rear Brake Light Pressure Switch
All Aftermarket Rear Sets eliminate the rear brake light activator spring. The Rear Brake Light Pressure Switches replace the banjo bolt in your Rear Brake Master Cylinder and wire directly into your existing Harness with two wires.
Choose FT (Fine) Thread or CT (Coarse) Thread models from the drop down boxes, FT is Gen 1 SV650 and CT is 2003 and newer SV650 or Gladius models as an Example.
If your bike uses Course Thread, 1.25 pitch Banjo Bolt then you order the CT RBLPS. If your bike uses Fine Thread, 1.0 pitch Banjo Bolt then you order FT RBLPS.
This is a very simple install. Once installed the RBLPS will allow the brake pedal to operate the rear brake light regardless of the rearsets used or the future mods you do.
The Front Brake Lever continues to operate the rear brake light regardless of the RBLPS install.
Available in stock for virtually all bike models utiliziing pressurized brake lines.